Before starting the installation of the foil, turn off the device, remove the battery from the device (if this is possible and the battery is not stapled).
STEP 1
Wash your hands and fingertips well. We recommend that the foil be applied in an environment with clean air, without too much dust (bathroom, kitchen)
STEP 2
To avoid imprinting the film, we recommend that you moisten the tips of your fingers throughout the installation with the solution from the package. You must also wipe the phone very well and remove all dust particles.
STEP 3
Peel off the foil from its support, identify and remove the cutouts (for the camera, speaker and buttons)
STEP 4
Spray the installation solution on the adhesive surface of the film. The foil becomes non-sticky for about 5 minutes, during which time the foil can be positioned on the device with precision
STEP 5
Apply the film with the adhesive side down, on the device, finding the perfect position
STEP 6
We recommend on the applicator card to use the microfiber cloth for application. Use the applicator card together with the cloth to remove liquid and bubbles with movements from the inside to the outside of the device
STEP 7
Wipe the excess liquid from the device with the microfiber cloth
IMPORTANT
When you remove the excess liquid, it drips onto the edges, making them non-sticky for about 30 minutes. You have to wait until the foil adheres to the curved edge, and then insist with the palm of your hand, until the foil sticks completely.
After installation, leave the device off for at least 12 hours to allow the liquid to evaporate and the film to adhere as well as possible to the device. Liquid or air bubbles disappear by themselves in 24-48 hours after application.